Daystar KG09109 Bedienungsanleitung PDF herunterladen

TOOLS NEEDED

Floor Jack X 1

Jack Stands X 2

Puller Tool X 1

Hand Tools

18mm socket and wrench

BILL OF MATERIALS

P11321 X 2 Torsion Keys

P11402 X 1 Instructions

IMPORTANT: The net amount of ride height increase de-

pends upon the age and use of the vehicle, wheel offset, and

numerous other factors. Stated torsion bar ride height in-

creases are based upon factory specifications. If the torsion

bars were “cranked up” at some point in the past, expect a

corresponding reduction in overall height increase with the

new torsion keys. Note that torsion bars, like any other

spring, are subject to fatigue and sagging over time. Also,

torsion bars have different ratings depending on how the vehi-

cle was equipped from the factory. In some cases, installing

heavier rated bars (which can be purchased from a dealer)

may be the only solution to regaining ride height lost from

adding heavy aftermarket accessories, such as a winch

bumper or snow plow.

NOTE: Various types of puller tools are available, however, due to the

extreme loads present in four-wheel drive suspension systems, we have

found the two-jaw style tool that clamps to the crossmember tends to slip

and damage the crossmember. A C-clamp style puller tool is preferred

and available through tool companies such as OTC and Kent Moore.

WWW.DAYSTARWEB.COM

Instruction Sheet P11402

2007 Daystar Products International Inc.

www.Daystarweb.com

Tech Support Contact Info

[email protected]

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

KG09109

2000-06 AVALANCHE/TAHOE/YUKON/

ESCALADE/SUBURBAN WD

TORSION BAR LEVELING KIT

1 2 3 4

Inhaltsverzeichnis

Seite 1 - TORSION BAR LEVELING KIT

TOOLS NEEDED Floor Jack X 1 Jack Stands X 2 Puller Tool X 1 Hand Tools 18mm socket and wrench BILL OF MATERIALS P11321 X 2 Torsion Keys P11402 X

Seite 2 - Product Use Information

Thank you for choosing Daystar Products Daystar recommends a certified technician install this system . In addition to these instruction , professio

Seite 3

9. Using extreme caution, tighten the puller tool enough to take the load off the adjuster bolt. Remove the adjuster bolt and nut block, then unlo

Seite 4 - Installation steps

1. Place the vehicle on a level surface. Prior to beginning, record ride height on each side of the vehicle by measur-ing from the center of the s

Kommentare zu diesen Handbüchern

Keine Kommentare

Daystar KG09109 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Daystar KG09109 herunter. Daystar KG09109 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Daystar KG09109